CDA RV921 Manual do Utilizador descarregar pdf (Página 9)

The hob can be set to the desired position by turning the control

knob through the adjustment range in an anti-clockwise direction.

Igniting The Burners

The hob is ﬁtted with a ﬂame failure

device. Flame failure devices

operate by shutting o the supply of

gas to the burner in the event that the

ﬂame is extinguished accidentally.

To ignite the burners, follow these instructions:

1. Lightly press the control knob down and turn the knob

anticlockwise to the maximum position. Firmly press and hold down

the control knob to begin the ignition process (a clicking sound

will be heard). Hold down the control knob for a few seconds after

ignition to allow the safety device to detect that the burner is lit.

2. Once the burner is lit, adjust the burner power to the required

position.

Please note:

• The ignition device should not be operated for more than 15

seconds.

• If a burner does not ignite, or turns o accidentally, turn the control

knob to the ‘o’ position, and wait for one minute before attempting

to reignite the burner.

• If the burner does not ignite, repeat the ignition process with the

burner at the minimum position.

Fig.3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Sem comentários

CDA RV921 Manual do Utilizador Página 9