CDA FW422 Ficha Técnica

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu

10dust, and not touching the rear wall.• There is enough ventilation at the side and rear walls. • The temperature of the room is adequate (10°C or

11InstallationProduct Dimensions and aperture required for installation:Your refrigerator is designed to be installed into a standard larder unit of w

1221B-Cfig. 5Fig. 3 - Fitting the decor door bracketUnscrew and remove the nuts and washers from the appliance door. Place fixing bracket on the applia

13fig. 8Fig. 6 - Aligning the decor doorClose the door and check the alignment with the other unit doors. Adjust the decor door by screwing or unscrewi

14Fig.9 - Fitting the plinthFit the plinth section, providing minimum 25 mm gap between the cabinet door and fix it.Never cover over the ventilation sl

15Reversing the DoorIt is possible to reverse the door on this appliance, if required. To do so, follow the steps below:1. Open the door.2. Remove t

16Electrical InformationWarning! This appliance must be earthed.The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To

17As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plu

18NOTES

19NOTES

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang

3This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) and E

4ImportantNever store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.This is a household appliance, which is pro

5Before First UseYou must allow the fridge to settle for at least twenty four hours prior to switching the power on.It is recommended that you clean t

6Setting the TemperatureYou must allow the fridge to settle for at least twenty four hours prior to switching the power on.To adjust the temperature t

7• Sort foods prior to storing. Any foods to be used soon should be stored at the front of the shelf to prevent deterioration caused by the door bei

8Once cleaning is complete, then reconnect the power.• Keep the door gasket clean. If damaged, the gasket should be replaced.• If the appliance is

9Changing the Light BulbDisconnect the appliance from the power.• Carefully remove the light cover by pushing in the lever at the back of the cover,