CDA HCC662 for Manual do Utilizador descarregar pdf (Página 10)

How to Install the Hob

How to install the hob:

Overall dimensions of the hob: Width: 580mm Depth: 510mm

Worktop cut-out dimensions: Width: 560mm Depth: 490mm

1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood

to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out

edge. The distance from the hob, when ﬁtted, to the back wall is 50mm. If a splashback/worktop upstand is to be ﬁtted,

take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear

wall or splashback is 50mm.

2. Position the hob seal, as shown in Fig.6, ensuring that the ends meet without overlapping. Do not use silicone type sealant.

3. Secure the hob to the worktop using the ﬁxing brackets and screws supplied, as shown in Fig.7. Remove any excess sealant

after tightening the brackets. Do not over-tighten the ﬁxing brackets.

3cm

4cm

65mm

470mm

550mm

150mm150mm

Fig.4 Fig.5

400mm

185mm 185mm

60mm

480mm

560mm

190mm190mm

Fig.6 Fig.7

650mm (600mm minimum)

1 2 ... 5 6 7 8 9 10 11 12

Sem comentários

CDA HCC662 for Manual do Utilizador Página 10