CDA hn3620 Especificações

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10Using Your Hob The table below oers guidance as to what each power level is for.To switch the hob onTo switch the power on, touch and hold the key

11To turn the power oTo switch o a single zone, touch the “Selection” key for the zone no longer required. Touch the “-” key until the zone display

12• At the end of the set time, the selected zone will switch o and the timer display will ash “00”. The hob will beep for approximately one mi

13and hold the timer “+” or “-” keys to scroll through the duration quickly.• After approximately ve seconds, the control LED stops ashing and th

14in the relevant zone display after cooking until the zone is at a safe temperature to touch. In the event of a power cut, the residual heat indicto

15Ecient Use of Your HobThe hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, on

16Care and MaintenanceAlways disconnect the appliance from the power supply before undertaking any cleaning or maintenance.Important: • Steam cleaner

17In the event of a fault with the hob, please advise CDA Customer Care of any fault code shown on the displayContact CDA Customer CareA: Customer C

18IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your ap

19IMPORTANT: When correctly installed, your product meets all safety requirements laid down for this type of product. However, special care should be

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note th

20ventilation grille. • The furniture top rail should not be fitted to the unit. This allows the induction hob to exhaust air into the kitchen space.

21on the hob may not allow the hob to be used at the same time as a pyrolytic programme on the oven.• The hob is equipped with an anti-overheating

22How to Install the Hob:Overall dimensions of the hob:Width: 300 mm Depth: 510 mmWorktop cut-out dimensions:Width: 275 mm Depth: 490 mm1. Make

23Mains Electricity ConnectionWarning! this appliance must be earthedWe recommend that the appliance is connected by a qualified electrician, who is a

24appliance should be marked on the outlet (13A).• Assembly and electrical connection should be carried out by specialised personnel.• When installi

25the absense of an earth connection or a faulty earth connection.

26NOTES

27NOTES

Please contact our Customer Care Department for Service on the details belowCustomer Care Department • The Group Ltd. • Harby Road • Langar •

32004/108/EC. Parts intended to come into contact with food conform to 89/109/EC.IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDAN

4surface prior to use.• Do not modify the appliance in any way as this will invalidate the guarantee and is potentially dangerous.• The hob top is

5capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and

6divider must be made of material capable of withstanding 65°C above ambient temperature.• Never place inammable items or materials in a drawer or

7FOR THOSE WITH HEART PACEMAKERS OR ACTIVE IMPLANTS:The function of this hob conforms to current electromagnetic interference standards and thus is in

8Cooking On InductionThe principle of induction cooking is based on magnetic eect.When you put your cookware on an induction zone and switch it on, t

9Using Your Hob Fig.1Control panel: 3. Power key4. Timer display5. Zone selection keys6. Zone displays7. - key8. + key9. Timer control light Zones:1.