CDA hn6110 Especificações

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10Using Your Hob The table below oers guidance as to what each power level is for.To switch the hob onTo switch the power on, touch and hold the key

11To turn the power oTo switch o a single zone, touch the “Selection” key for the zone no longer required. Touch the “-” key until the zone display

12• Touch both the “+” and “-” keys at the same time to select the timer. The timer display will show “00”.• Set the required duration using the

13Minute minderWhen no cooking zones are being used, the timer can be used as aminute minder.To Set the Minute Minder• Touch both the “+” and “-” k

14To turn o the key lockIf the hob is not already turned on, turn it on by touching the key. Touch the “-” key and the “Zone selection” key for the

15zone. The zone will switch o after approximately one minute if no suitable pan is placed on the zone. Ecient Use of Your HobThe hob is equipped w

16Care and MaintenanceAlways disconnect the appliance from the power supply before undertaking any cleaning or maintenance.Important: • Steam cleaner

17In the event of a fault with the hob, please advise CDA Customer Care of any fault code shown on the displayContact CDA Customer CareA: Customer C

18In useYou observe that Possible Causes What should you do?One or all of the zones cuts out.The safety system has cut out.Leave hob to cool then try

19IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your ap

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note th

20damage to the hob and constitutes incorrect installation, which is not covered by the warranty. Notes: • This could be a simple slot cut out of th

21temperature.• Never place perishable foods, soft items such as tea towels, cleaning products or ammable items in the cupboard or drawer below the

22How to Install the Hob:Overall dimensions of the hob:Width: 590 mm Depth: 520 mmWorktop cut-out dimensions:Width: 560 mm Depth: 490 mm1. Make

23Mains Electricity ConnectionWarning! this appliance must be earthedWe recommend that the appliance is connected by a qualied electrician, who is a

24connection box.• As the appliance is not tted with an accessible plug, a means of disconnection from the power supply must be must be included in

25The following diagram shows the mains connection: * Calculated using the diversity factor following the standard EN 60 335-2-6/1990.Any service cal

26NOTES

27NOTES

Please contact our Customer Care Department for Service on the details belowCustomer Care Department • The Group Ltd. • Harby Road • Langar •

32004/108/EC. Parts intended to come into contact with food conform to 89/109/EC.IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDAN

4surface prior to use.• Do not modify the appliance in any way as this will invalidate the guarantee and is potentially dangerous.• The hob top is

5capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and

6divider must be made of material capable of withstanding 65°C above ambient temperature.• Never place inammable items or materials in a drawer or

7FOR THOSE WITH HEART PACEMAKERS OR ACTIVE IMPLANTS:The function of this hob conforms to current electromagnetic interference standards and thus is in

8Cooking On InductionThe principle of induction cooking is based on magnetic eect.When you put your cookware on an induction zone and switch it on, t

9Using Your Hob Fig.1Control panel: 3. Power key4. Timer display5. Zone selection keys6. Zone displays7. - key8. + key9. Timer control light Zones:1.