
1Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : c
10Use and Controls Should the clothes dry before the cycle has finished the thermostat will automatically switch o the heater to prevent over drying a
11Suppliers name or trade mark CDAModel identifier CI921Rated capacity at full load 7kgAppliance type Air VentedEnergy efficiency class CEnergy consum
12Care and MaintenanceCleaning The FilterThe filter is found, by opening the door (fig.2.) and must always be in position when drying items in the appl
13Troubleshooting If the clothes are not dry after normal drying time:- Check that the filter is clean.- Check that you used the correct heat setting.-
14Installation / VentingThis appliance is fully compatible with any 600mm deep kitchen units and complies with stringent EEC regulations.Your dryer is
15 PLEASE NOTE: The air vent at the front of the appliance must never be covered or blocked in any way as this will impair the functioning of the appl
16Reversing the DoorThe door on the dryer can be positioned either with the left or right hand hinging, as shown in fig.6. Please note: power tools mu
17Electrical InformationWarning! This appliance must be earthed.The mains lead of this appliance has been fitted with a BS 1363A 13 Amp fused plug. To
18As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug
2User Information The room must be adequately ventilated to avoid the backflow of gases into the room from appliances burning gas or any other fuels.
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu
3flammable substances in the tumble dryer.• Attempt to dry dripping wet articles.• Dry unwashed items in the tumble dryer.• Dry wool or wool
4ImportantThis appliance must only be used for the purpose for which it is intended, i.e. domestic use. Any other use could be dangerous and may lead
5CE Declarations of Conformity:This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directives 200
6Use and Controls 1. Programme selector: Choose the final dryness of the load by selecting the desired dryness setting (see the programme chart).
7Programme ChartProgrammes 1-7 can be operated on either full heat or half heat setting and include a 12 minute cool-down period at the end of the cyc
8To Run a Programme• Sort out the clothes into groups of similar fabrics and colours. Check the care label inside the garment. We suggest that a fab
9• The drum will begin to turn, and will stop when the clothes are dry. The drum will rotate clockwise and anticlockwise during the programme alter
Comentários a estes Manuais