CDA HG3602 Manual de Serviço descarregar pdf (Página 16)

3 cm

min

3 cm

4 cm

Fastening the Cooktop

Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop

to benches from 30 to 40 mm thick.The kit includes four R brackets and four self-threading screws S (ﬁgs.

19, 20).

– Cut the unit according to the dimensions in ﬁg. 16.

– Turn the hob upside down and rest the glass side on a soft surface.

– Spread the seal G around the edge of the hob (ﬁg. 19).

– Fasten the brackets R to the appropriate socket holes, without tightening the screws S for the moment.

Make sure that the tabs are mounted correctly, as shown. Rotate the tabs so that the cooktop can be

put into the cutout.

– Put the cooktop into the cutout and position it correctly.

– Put the brackets R into place; tooth A of the brackets should go into the hole (Fig. 20).

– Tighten screws S until the cooktop is completely secured to the bench.

– Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop.

Take care not to damage the workbench.

Fig. 19

Fig. 20

Adhesive side

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

CDA HG3602 Manual de Serviço Página 16