CDA CST Manual do Utilizador descarregar pdf (Página 9)

Mounting your Extractor

The extractor can be mounted in one of two ways:

To fasten the product to the underside of a bridging cabinet:

To fasten the product to the underside of a bridging cabinet remove the grease ﬁlter cover and screw the hood directly to the

cabinet using appropriate wood screws (Not supplied).

To mount the hood on to a wall, proceed as follows:

1. Drill four holes as shown in the diagram below, corresponding to positions B and Z on the diagram. Note that the size of

the holes dependant on the wall ﬁxings you will be using.

2. Insert the wall ﬁxings into the hole (B) and tighten the ﬁxing screw, leaving about 2 to 3mm proud of the wall. Insert wall

ﬁxings in to the position Z for use later.

3. Hang the hood on the ﬁxing screws and secure the hood in position using two screws ﬁxed to the wall ﬁxings in position Z.

Ducting and Ventilation

For best performance and lowest noise output, we recommend the use of 125mm ducting. You can also use 100mm ducting

but this will reduce performance.

If the extractor is to be used in recirculation mode, ensure that the lever (E) on the base of the motor is turned from

position A (ducted) to position F (re-circulation), as shown in Fig 2.

Fig. 4

1 2 3 4 5 6 7 8 9 10

Sem comentários

CDA CST Manual do Utilizador Página 9