CDA HVG93 Manual de Serviço descarregar pdf (Página 13)

Installation

Technical Information For The Installer

In order to install the cooktop into the kitchen xture, a hole with the dimensions shown in g. 16 has

to be made, bearing in mind the following:

– Within the unit, between the bottom of the cooktop and the upper surface of a shelf there must

be a clearance of at least 30mm.

 It is absolutely essential that you place a separator between the base of the cooktop and the built-

in unit or the oven;

– The cooktop must be kept no less than 240mm away from any side wall (between the side of the

cut-out and the side wall - g. 15).

– There must be a distance of at least 135mm between the back side of the cut-out and the back of

the countertop (g. 16).

– There must be a distance of at least 650mm between the hob and any wall cupboard or extractor

hood positioned immediately above (see g. 15).

– If the hob is installed over a built-in oven, the built-in oven shall be provided with cooling fan.

 The two appliances shall be connected to the gas/electric supply with independent connections.

500 mm

650 mm

450 mm

240 mm minimum between

the side of the cut-out and

the side wall

Fig. 15

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sem comentários

CDA HVG93 Manual de Serviço Página 13