CDA HVG93 Manual de Serviço descarregar pdf (Página 15)

Fastening the Cooktop

Each cooktop is provided with an installation kit including brackets and screws for fastening the co-

oktop to benches from 30 to 40mm thick.The kit includes two “F” type brackets (for the front of the

cooktop), two “R” type brackets (for the rear of the cooktop) and four self-threading screws “S” (gs. 19a

and 19b).

– Cut the unit according to the dimensions in g. 16.

– Turn the hob upside down and rest the glass side on a soft surface.

– Spread the seal “G” around the edge of the hob (g. 18).

– Fasten the brackets “F” and “R” to the appropriate so-

cket holes, without tightening the screws “S” for the

moment. Make sure that the tabs are mounted cor-

rectly, as shown. Rotate the tabs so that the cooktop

can be put into the cutout.

– Put the cooktop into the cutout and position it cor-

rectly.

– Put the brackets “F” and “R” into place; tooth “A” of

the brackets should go into the hole (Figs. 19a and

19b).

– Tighten screws “S” until the cooktop is completely

secured to the bench.

– Using a sharp cutter or trimmer knife, trim the excess

sealing material around the edge of the cooktop.

Take care not to damage the workbench.

3 cm

min

3 cm

4 cm

3 cm

min

3 cm

4 cm

Adhesive side

Rear Fixing Brackets Front Fixing Brackets

Fig. 19bFig. 19a

Fig. 18

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sem comentários

CDA HVG93 Manual de Serviço Página 15