CDA HVG93 Manual de Serviço descarregar pdf (Página 18)

Gas Connection

Cat: II 2H3+

The tting (g. 20) is made up of:

– 1 nut “A”

– 1 elbow tting “C”

– gasket “F”

Connection to the Gas Supply

• Be careful when exible pipes are used that they

do not come into contact with moving parts.

• To maintain the thickness of 3 cm, the hob is

tted with a channel to contain the connection

pipe.

• The gas inlet union can be turned in the direc-

tion required after the elbow tting “C” and nut

“A” connection (gure 20) has been slackened

(Fig. 21).

• Never put it in the horizontal or vertical position.

• Never attempt to turn the elbow “C” without having rst slacke-

ned o the relative lock nut “A”.

• The gasket “F” (g. 20) guarantees the seal of the gas connection.

 It is recommended that it be replaced whenever it shows even

the slightest deformation or imperfection.

• Using a suitable leak detection uid solution (e.g. Rocol)

check each gas connection one at a time by brushing the so-

lution over the connection.

 The presence of bubbles will indicate a leak. If there is a leak,

tighten the tting and then recheck for leaks.

 IMPORTANT! Do not use a naked ame to test for leaks.

If installation is to be carried out using a exible connector (to BS669), then the following points must

be adhered to:

Note: The gas installation pipes and the nal connection to the appliance connecting pipe shall be

sucient size to maintain the heat output of the appliance as specied under installation.

1. The appliance exible connector should not be subject to undue forces, either in normal use whilst

being connected or disconnected.

2. The appliance exible connector should not be subject to excessive heat by direct exposure to ue

products or by contact with hot surfaces.

3. The socket into which the plug of the appliance exible connector ts should be permanently

attached to a rmly xed gas installation pipe and positioned such that the hose hangs freely

downwards.

4. The appliance exible connector should be positioned such that it will not suer mechanical da-

mage; eg abrasion from the surrounding kitchen furniture which may be moved in use, such as a

door or drawer, or by being trapped by a stability device.

5. The plug-in connector should be accessible for disconnection after moving the appliance.

1/2" G conical

(ISO 7-1) male

1/2" G cylindrical

(ISO 22 8-1) male

1/2" G cylindrical

(ISO 22 8 -1) female

C F A

Fig. 21

Fig. 20

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

CDA HVG93 Manual de Serviço Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões CDA HVG93