CDA PC44 Instruções de Operação descarregar pdf (Página 34)

3-12 Installation

Solenoid Wiring Installation

Gun

Solenoid

Wiring

108

3891\

57·28 1/93

NOTE: The PC40 240 VAC Pattern Control uses 220/240 VAC

solenoids to actuate pneumatic guns. The unit should not

used

actuate electric gun drivers. If you are using electric gun drivers, order

the

PC40

Pattern Control (P/N

131

709) and PS40

Power

Supply (PIN

131

739}.

1. Install the gun solenoid(s} following the instructions provided

the

manual you received with your applicator.

If you have not already done so, temporarily mount

the

front

assembly to the back enclosure by doing the following:

a. Loosen the six screws on the front assembly.

b. Remove the two top screws (Figure 3.5).

c. Rotate the front assembly

1ao·

(Figure 3.

Push the two screws through the top two front assembly holes

(Figure 3.7, view

e. Insert the two screws into the two back enclosure stand-offs

(Figure 3.7, view A).

1ighten the two screws

secure the front assembly

the back

enclosure (Figure 3.7,

view

B).

3. Route the two leads (three

the solenoid has a ground wire) to the

PC40 through water-tight conduit (for an IP-54 enclosure rating) and

the strain relief connector.

WARNING: Risk

electrocution.

The

input power line

the PC40 provides voltage that can cause personal injury

death. Before making

any

electrical connections, disconnect

and

lock out power to the main circuit breaker for the input

power

line (see Figure 3.8).

WARNING:

Shock hazard. Touching bare wires in the PC40

can result in shock that can cause personal injury

death.

When making electrical connections, make sure

strip only

as much insulation from the wires as needed. Also, make

sure that the insulation fits snugly against the

PC40 terminal

blocks.

Nordson Corporation 1993

AJI

R•

Rese

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 103 104

Comentários a estes Manuais

Sem comentários

CDA PC44 Instruções de Operação Página 34

Comentários a estes Manuais