CDA PC44 Instruções de Operação descarregar pdf (Página 72)

4-16 Operating Instructions

Program Mode

Purpose

Accessing

Program Mode

LOCK

CON

GURE

PROGRAM

RUN

TEST

ME:MORY

Figure 4. 13 - Initi

ogram mode di

splay

(memory A sel

ted

act

ive)

1 -

·x· flashing

Changing

Selection Levels

Exiting

Program

Mode

PIN t 08

38!1.>.

57·28

l/93

NOTE:

• If

you are programming a PC40 that has previously been

programmed, not all the parameters you want to program may

available. Follow the instructions in "Run Mode" (uReviewing

Parameters and Value

s")

later

this section.

the parameters

you want to program are displayed

the review, return to this

secti

and proceed with the followi

instructions.

• If the parameters you want

program are not displayed

the

parameter review, follow the instructions in

"Configure Mode" (in

this section) to make the parameters available. Then, return to

this section and proceed with the following instructions.

NOTE: If power is interrupted while changes are being made in the

Program mode, those changes will not

stored in memory. As soon

as you are finished making changes, be sure to exit the Program mode.

This saves all changes.

This mode provides you with the ability at system start-up

while the

unit is operating to

• program or change the active memory;

• program inactive memories;

• activate or deactivate channel, trigger, transiti

on,

and stitch

selections; and

• set

change the numerical values.

Press and hold SET. The initial Program mode display appears

(Figure 4.13).

While "X" is flashi

, press DOWN or

UP.

ile "X" is flashing on any selection leve

press SET. The default

display will appear (Figure 4.12).

Nor

dson Corporalion t

All

Rrghts Reserv

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 103 104

Comentários a estes Manuais

Sem comentários

CDA PC44 Instruções de Operação Página 72

Comentários a estes Manuais